6‑Pack DRV8833 Dual DC Stepper Motor Driver Module, Pre‑Soldered Pins, H‑Bridge Controller Board Compatible with Arduino, Raspberry Pi, ESP32

Particulars: Input voltage: 2.7V-10.8V Single H-bridge output current: 1.5A Can drive 2pcs DC deceleration motors Size: 18*21*11mm Weight: 3g Use: can drive DC motors below 1.5A and 4-wire stepper motors. Built in overcurrent protection, short circuit protection, undervoltage lockout, and overheat protection. With low-power sleep mode. DRV8833 Pin description: AIN1: The logic input control port of AO1, with a voltage level of 0-5V. AIN2: The logic input control port of AO2, with a voltage level of 0-5V. BIN1: The logic input control port of BO1, with a voltage level of 0-5V. BIN2: The logic input control port of BO2, with a voltage level of 0-5V. AO1 and AO2 are 1-channel H-bridge output ports, connected to two pins of a DC motor. BO1 and BO2 are 2-channel H-bridge output ports, connected to the two pins of another external direct motor. GND: Ground. VM: Chip and motor power supply pins, voltage range 2.7V – 10.8V. STBY: Grounded or suspended chip does not work, no output, connected to 5V for operation; Level 0-5V. NC: Empty feet.

• This DRV8833 motor‑driver module serves as a direct replacement for TB6612 module with pin‑to‑pin compatibility.
• Input Voltage: 2.7V‑10.8V. Each single H‑bridge delivers 1.5A continuous output current.
• It can drive 2 units of geared DC motors as well as 1.5A‑rated DC motors and 4‑wire stepper motors. Suitable for projects such as robots and small intelligent vehicles.
• Built‑in overcurrent protection, short circuit protection, undervoltage lockout, and overheat protection. With low-power sleep mode
• This chip supports forward and reverse rotation, braking, and standby functions, with specific features of high efficiency and low power consumption.